Stock Rom Flash File (ROM) also helps you to repair the Mobile device, if it is facing any Software Issue, Bootloop Issue, IMEI Issue, or Dead Issue.

It also helps you to fix the device if it is having any Software related issue, Bootloop issue, IMEI related issue.

There is no change in the firmware and it was scanned by Kaspersky Internet Security before sharing it online.

So make sure you backup all your important data before proceeding.

It helps you to recover the Huawei B315S-936 device, if it ever gets a boot loop, software error, update error, hanging, and dead issue.

Note: select proper COM port in your CID reader before entering the codes below.

To check if you have chosen the right COM Port, click on Read IMEI.

The Logs window should display the modems IMEI number otherwise select a different COM Port.

You might brick your modem (Joke lang).

Enter the following commands: First Code: This Query Datalock Status Value.

Default value is 1 (Enabled) atdatalock Second Code: This Sets The Datalock Value to 12345678 AT NVWREX 50502,0,128,4A FB 2D 5A 34 74 86 F0 A6 CC AE 46 99 53 83 1D 5C B1 7E 2A EF B2 B0 1A EF 53 03 8E C8 FF 1C 0D 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 8B 8C F4 B5 AF 0C F2 2C FE E0 F4 46 9C CF 47 95 36 71 1F 1C BF 05 7F 84 AB A9 F2 92 89 33 3C 01 00 00 12 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 Third Code: This Sets Datalock Status value to 0 (Disabled) atdatalock12345678 Fourth Code: This will set your modem to factory mode atsfm1 Fifth Code: This will reset your modem.

Wait until the modem reboots and shows a ATreset ---Steady power light indicator Only 4) Connect your modem to your PC via LAN Cable Under Network Properties, Set IP manually as follows: click Use the Following IP Address IP address: 192.168.1.100 Subnet Mask: 255.255.255.0 Gateway: 192.168.1.1 Tick Use the following DNS Server Adressess Preferred DNS: 192.168.1.1 Alternate DNS: (leave blank) Click OK 5) Run Config Updater login kayo user user pero minsan kahit wala start nyo lang and wait for it to complete successfully.

Enter USB mode (back to Step 1 USB Mode link) Run CID reader in USB mode and enter the following commands: Pag ayaw mag telnet kayo 192.168.1.1 duon nyo input yan.

Telnet 192.168.1.1 user:admin pas:admin or user:user password:user First Code: This command will kick your modem out of factory mode atsfm 0 Second Code: Resets and reboots the modem ATreset 7) After successfully rebooting, go to Network Properties again and click Obtain IP Address Automatically and Obtain DNS Address Automatically.

Choose Restore Default The modem will reboot.

Done. You now have admin access to your modem.

Enter this command: ATCGDCONT1, IP,internet Last command Reboots the modem.

B315S 936 Firmware